8 easy ways to install a bathroom shower, plus bathroom shower care tips

More modern minimalist homes are being used A shower , because it is considered more convenient for cleaning oneself.

In addition to using shower Showering is considered a way to save more water than regular bathing.

Especially with the shape of the tap shower Different shapes, of course, will make the bathroom look basic I saw My beauty .

However, you need to pay attention to how it's installed. shower Hot and cold water, of course, for it to work properly.

Then how to install shower toilet?

How to install a suitable bathroom shower

1. Preparing the water pipe

First step of installation shower The bathroom is for preparing the pipe for the water line.

The size of the pipe needed to create a water channel will of course vary depending on the installation in the bathroom.

2. Installing the water tap

In addition to installing the pipes, you also need to install the taps. shower The wall, specifically there is a section for the water tap.

If the bathroom is equipped with water heating facilities, you should set up separate taps for hot and cold water.

This is done so that you are more comfortable when using it Shower set in the bathroom.

3. Install a faucet stop

The next step is to install two stations for hot and cold water taps, positioned close together. shower wall.

Use a metal tap for hot water and a plastic tap for cold water.

4. Installing the shower pipe

How to install shower The next bathroom installation involves a flexible pipe measuring 25 cm - 30 cm.

Also install a 12-inch iron pipe with nipples In the end.

5. Use welding tape

Next, apply tape seal On each part of the thread or tap groove.

Continue by securing the hot and cold tap stoppers to the screw plug. Ensure there are no leaks!

6. Install the T-tube.

Next, attach the iron T-tube to one of the tap stops. Ensure the tube is securely fastened and does not leak or drip.

7. Connect the flexible tubes

Next, connect the flexible tube to the end of the tap stop and tighten it. The nipples are tightened using a wrench.

8. Install the shower hose

Finally, install the hose, and also install the hanger on the bathroom wall.

Therefore, shower The bathroom wall in your home is ready for use.

Bathroom shower care tips

After understanding how to install it, you of course need to know how to take care of it.

1. Clean the exterior surface of the shower

A. Dry shower Which is still damp with a soft cloth so that the surface does not peel.

b. This is followed by applying a special cleaning fluid to protect the chrome layer on the surface. Shower .

c. After applying the cleaning fluid evenly, rub the surface until it is clean and shiny.

2. Cleaning inside the bathroom

Typically, with use, internal shower Dirt will clog the water due to the iron content.

This causes water to drain into shower It becomes clogged, so it must be cleaned carefully.

A. Open the flexible hose by rotating it in different directions.

B. Next, continue flushing the clogged filter. This filter is usually located between the flexible hose and Manual shower .

C. For the part Manual shower , clean with a hole punch shower Until it becomes clean.